The MICROBEAST is a 3 axis gyro system for RC helicopters. This technology allows the user to go flybarless. It has an aluminum composite design casing. The slight dimensions allow it to be installed in practically any model helicopter and can be installed horizontally as well as vertically. The sensory system is based on the newest MEMS technology. Software with sophisticated sensor data processing makes installation in electrical & nitro model helicopters possible. With an optional adapter cable, the Microbeast can also be utilized solely as a tail gyro. This is recommended especially for whoever is switching from the conventional paddle system and wants to slowly approach the RIGID operation with the 3 axle solution (3G-Gyro Mode). The well-thought-out and easy setup goes smoothly with no need of an expensive programming box or computer. This makes it easy to still change a number of settings even at the airfield. Moreover MICROBEAST′s integrated swashplate mixer enables the use of simple remote control systems which do not have their own swashplate mixing. Features: Single unit, no additional sensors to install Aluminum and composite case Lightweight (28g)including mounting pad and wires Suitable for Nitro or Electric use Multiple mounting positions Simple programming without PC, laptop or console PPM / S-BUS / Spektrum satellite receiver compatible Compatible with 90, 120, or 140 degree swashplates Specifications: Operating Voltage: 3.5V-8.5 VDC Processor: 32Bit ARM Analog Processing: 17Bit Sensor Technology: 3 MEMS angular rate sensors Adjustable Servo Center Pulse Width: Tail: 760μs / 960μs / 1520μs Adjustable Servo Pulse Rate: Tail: 50 Hz / 165 Hz / 270 Hz / 330 Hz Swashplate: 50 Hz / 65 Hz / 120 Hz / 200 Hz Built-In Swashplate Mixer: Mechanical / 90° / 120° / 140° Serial Pulse Input: PPM / S-BUS / Spektrum-satellite* Size: 34 x 25 x 13.5mm Weight Without Cable: approx. 20 g